A regulator is the clock a watchmaker keeps on the wall to set every other watch by. It splits the time up instead of stacking it: the one long hand in the middle counts minutes only, the hour sits on its own small dial near the top, and the seconds turn in a second small dial near the bottom.
That is the whole idea here, borrowed from the page rather than from the workshop. On a hand-copied page the heading is written in red and read first; on this dial the hour is the heading, printed in red on its own small dial. The minutes are the body text, in ivory, numbered every five all the way round the edge. The date sits in a ruled box out in the left margin, where a note to the reader would go, which is why this face is deliberately not symmetrical.
Nothing here is modelled in metal. Every rule is a hairline, there is no gloss, no bevel and no drop shadow; the ink ground only darkens very slightly towards the rim, the way a sheet does. Red is the only colour on the dial and it is the hour's: the figures and the hand of the small hour dial, and the dot in the collar at the centre.
Always-on display: the ink ground, the minute figures, the seconds dial and the margin box all switch off. What is left is the small hour dial with its hand, the long minute hand as an outline, the open collar at the centre, and four marks at the quarters.
- One complication slot, replaceable in the watch face editor: Margin (day and date) by default.
- Every rule, figure and dial here is pure vector geometry generated from code, so the design stays crisp when scaled down to a smaller watch.
- Built with the Watch Face Format; needs Wear OS 4 or newer.
The small registration cross near the lower right is this studio's mark, used in printing to line up one ink plate over another. Every rule, figure and hand on this dial was drawn for this face; nothing is taken from, named after, or made to resemble any watch brand.
A regulator: the hour on its own small dial, the long hand counts minutes.
আপডে’ট কৰা তাৰিখ
২০২৬ নৱে ১৪